Eli alkoi vilkuttaa tota valoa ja tiputti tehot. Vaihdoin remmin, vaikkei silmämääräisiä vikaa näkynytkään, ja vipu on off asennossa.
Mutta kuittaus?
Millä ilveellä se kuitataan? Ohjeita YouTube pullollaan, mutten löydä tohon laitteeseen sopivaa, tai sitten en vaan löydä niitä ”ristiin kytkettäviä” liittimiä
Step by step ohjeita olisin siis vailla,kiitos.
Brute 650 -06 belt kuittaus?
- ViiMax
- Tracks
- Viestit: 4448
- Liittynyt: 13 Helmi 2011 13:10
- Mönkijä:: Sp 500
- Paikkakunta: Nurmijärvi & P-Karjala
Re: Brute 650 -06 belt kuittaus?
Tämmönen löytyi:
Turn off the ignition switch.
Remove the seat.
Disconnect both sets of 4 pin connectors in the electrical parts case.
Reconnect these 4 pin connectors to their opposite gray to black and black to gray.
Turn on the ignition switch.
Observe the belt check indicator light. (It should be flashing quickly.)
Disconnect the belt switch at the 2 pin connectors above the torque converter cover.
Observe the belt check indicator light. (It should be flashing slowly.)
Let it flash for at least 5 seconds. (More than 5 is ok.)
While observing the belt check indicator light, turn off the ignition switch.
Disconnect the mismatched 4 pin connector sets and reconnect them normally.
Connect the belt switch 2 pin connector.
Turn on the ignition switch.
Confirm that no belt check indicator light is flashing.
Put the connectors back and bend the clamps.
Turn off the ignition switch.
Remove the seat.
Disconnect both sets of 4 pin connectors in the electrical parts case.
Reconnect these 4 pin connectors to their opposite gray to black and black to gray.
Turn on the ignition switch.
Observe the belt check indicator light. (It should be flashing quickly.)
Disconnect the belt switch at the 2 pin connectors above the torque converter cover.
Observe the belt check indicator light. (It should be flashing slowly.)
Let it flash for at least 5 seconds. (More than 5 is ok.)
While observing the belt check indicator light, turn off the ignition switch.
Disconnect the mismatched 4 pin connector sets and reconnect them normally.
Connect the belt switch 2 pin connector.
Turn on the ignition switch.
Confirm that no belt check indicator light is flashing.
Put the connectors back and bend the clamps.
Re: Brute 650 -06 belt kuittaus?
https://youtu.be/1y32JE9NTL8
Samantien kun kysyin, löysinkin videon. Joskin multa puuttui toi ”kuittaus liitin”, joten homma hoitui hyppylangalla.
Samantien kun kysyin, löysinkin videon. Joskin multa puuttui toi ”kuittaus liitin”, joten homma hoitui hyppylangalla.